Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 142)

Device Emulation (Optional)
132
3. Define Device Descriptors. Click the Device Descriptor button and
enter the parameters for the Device in the Descriptor dialog, as shown in
Figure 100.
Figure 100 Defining Device Descriptors
Define Configuration
A Device initially opens with one configuration. You can add additional
configurations, up to a total of three, by clicking a Device then the
Add Configuration button.
To define configuration descriptors for each configuration, click the
Configuration Descriptor button and enter parameters for the configuration
in the corresponding descriptor dialog.
Enable Configuration Class Descriptor
Clicking this checkbox returns additional data as part of the
Configuration Descriptor. (up to 128 bytes).
Define Interface
Each configuration opens by default with one interface comprised of one
Alternative Setting with one endpoint. You can add additional interfaces up to
four per configuration, but not exceeding seven total for a Device, by clicking a
configuration then the Add Interface button.
To define alternative setting descriptors for each alternative setting, click the
Alternative Setting button and enter parameters for the alternative setting in
the corresponding descriptor dialog.
Enable Alternative Class Descriptor
Clicking this checkbox returns additional data as part of the
Alternative Descriptor (up to 128 bytes).