Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 193)

Display Manipulation
183
Timing Analysis Display
All USB signals are always captured and stored on disk, but may not be
displayed in the results display, unless you select them for display.
Click the Setup Screen button on the timing results display toolbar to open
the Active Signals Dialog box.
Figure 143 Active Signals Dialog Box
Select a signal in the Active Signals or the Remaining Signals list and use
the Add-> and <-Remove buttons to set up signals for display.
Insert blank line
To enhance readability, you can insert a blank line between displayed signals
by right-clicking in the timing display area between signal lines.
Choose Insert Blank Line.
Similarly, you can Insert additional signal lines, delete signal lines, or set a
bookmark.