Test mode, Programming the device – Teledyne LeCroy Conquest User Manual - Users Manual User Manual

Page 149

Text mode
Original mode

Device Emulation (Optional)

139

Test Mode

Test mode is used for working with a host without performing the enumeration
phase and setting the device address.
•

Set Address is not needed.

•

SetConfiguration and SetInterface commands are required to select
proper configuration and interface within the device.

Programming the Device

To open a new Advanced Device Emulation project, select File > New and
choose Advanced Device Emulation.

You can also open a default Advanced Device Emulation Project.

To open the default project, click the New Project button on the main toolbar
to open the Project Setup dialog and then click
Device Emulation & OTG Exerciser.