Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 103)

Protocol Analysis
93
Running the Project
Set Data Capture Options
Capture to Memory
You can limit the captured data display to a specific number of samples by
checking Partial Memory and entering the number of Samples to capture.
Alternatively, you can check Entire Memory to allow capture for the entire
memory. Choosing Partial Memory results in less time to display results.
Pre-Trigger
Pre-Trigger is set by default at 50%, which defines the percentage of data to
capture before and after the triggering event. You can change this percentage
by dragging the slider.
Pre-Trigger Data Limit - The capture of the specified percentage of the data
prior to the triggering event cannot be guaranteed and may in some cases be
0. This can occur if the triggering event occurs before the required amount of
pre-trigger event data can be stored. In these cases, the data display shows
fewer than the specified data points prior to the triggering event. For more
detail, see “Pre-Trigger” on page 107.
Auto Run
Continually captures data for the number of times specified. A separate data
file is generated each time that a capture is performed.
Run Project
To run the project, click Run and wait for the occurrence of a trigger event to
open the data capture result.
Figure 69 Data Capture Result
Display Manipulation
For details on configuring the data capture result display, see “Display
Manipulation” on page 175.