Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 20)

Installing the Analyzer
10
Installing the Analyzer
This section covers hardware and software setup.
Hardware Setup
You can set up the Analyzer/Exerciser in any of the following configurations:
•
As an Analyzer to analyze USB Host and Device transactions.
• As an Exerciser to exercise a USB Device.
• As an Analyzer/Exerciser for OTG Device testing.
• As an Analyzer/Exerciser in Hub testing.
• To measure Inrush current, Configured current, Unconfigured current,
Suspended current and VBus measurement
• As a Device for Host software testing.
Separate Systems
It is highly recommended that you employ separate systems for the Analyzer
software and the USB Host as shown in Figure 2 (the preferred configuration)
to analyze USB Host and Device transactions. Using just one system for both
functions can lead to confusing results because of shared bus traffic.
Figure 2 Conquest M2 Configured as an Analyzer
1. Connect Conquest M2 to a Parallel, USB, or Ethernet Port on a system
running the Conquest Protocol Suite software, with the appropriate
cable.
2. Connect the USB Device to the Main Analyzer Port on Conquest M2.
3. Connect the USB Host to the Main Analyzer Port on Conquest M2, using
a USB cable.
USB Host
Host Interface Cables
Windows Based System
With Analyzer Software
100V - 240V In
USB Device
Under Test