Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 17)

Introduction
7
Ports
Main Analyzer
This port supports Analyzer using 8 packets and a 32 state sequencer that are
used in Easy Mode or Advanced Mode for data capturing and triggering,
operating and unconfigured current measurement and timing analysis.
InRush
A dedicated connector to allow the measurement of USB Device Inrush
current.
Host Exerciser
A dedicated connector to exercise a USB Device and capture and trigger data
in conjunction with the Analyzer port.
OTG Exerciser
A dedicated connector to exercise an OTG Dual-Role or SRP- capable
Peripheral Device.
Device Emulation
A dedicated connector used when Conquest M2 is operated as a device.
Paral. Host Interface
Bi-directional Parallel Port interface located on the back of the unit for
connection between the Analyzer and the system hosting the GUI software.
USB Host Interface
Interface connection, located on the back of the unit, for connection between
the Analyzer and the system hosting the GUI software.
Note: Use only one, either Parallel Port or USB connection, for connecting the
Analyzer and the system software.
Power In
Conquest and Conquest M2 operate on 100V - 240V 50/60Hz power that is
connected on the back.