Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 30)

Launching the USB Analyzer
20
Launching the USB Analyzer
To launch the software, select LeCroy > Conquest in the Start menu or
double-click the Conquest Suite button in the Program Manager Window.
Each time you run the software, it searches for a default host interface and, if it
is found, the software launches. If no interface is found, the software launches
in simulation mode.
Establish Interface
If no interface is detected initially, then establish an available interface and
relaunch the software.
Click OK. The Analyzer launches and displays the Analyzer toolbar as shown
below.
Note: The very first time that you run the software, the USB Class Decodes loads.
This process takes approximately one minute.
Open sample file Open last saved project
Default data blocks
Mnemonics
Protocol error mask
Default capture
Set up project