Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 26)

Installing the Analyzer
16
Software Installation
On systems operating under Windows
®
2000, Windows XP, and
Windows Vista.
Note: Do not connect the Analyzer to the host system until software
installation is complete!
1. Insert the CD Rom in the CD Rom drive.
2. The installation automatically starts the setup, unless the Auto Run is
turned off. In this case, select the CD Rom from “My Computer” and click
setup.
3. After the warning to close all other programs and before starting the
installation, the Install component selection opens.
4. Select components for installation.
5. Click Next to complete the installation.
System Restart
You must restart the computer before you can use the Analyzer software.
Error Message
If you get an error message during installation of the drivers for Windows
2000, XP, or Vista, consult your system administrator. Your system may allow
only an administrator-level user to copy driver files.