Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 157)

OTG Exerciser (Optional)
147
Click the Advance OTG Exerciser icon to launch the OTG Exerciser.
Figure 109 OTG DRD Setup Dialog
Define the Device
1. Enable/Disable OTG Exerciser response to SRP by checking or
unchecking the A-Device SRP Support check box (Normally enabled).
2. If SRP is enabled, choose the response type as either Data Line
Pulsing or VBUS Pulsing.
3. Assign the Device speed from the Device Speed drop down list as Full,
or High. Note that the speed selection must match that of the DUT.
Create Exerciser Program
To program the OTG Exerciser, select the Program Exerciser Tab.
Programming the OTG Exerciser is identical to programming the Host
Exerciser as described starting on page 67. The following differences apply:
1. Not all of the commands available for the Host Exerciser are available
for the OTG Exerciser. Commands not applicable to OTG are grayed
out.
2. The OTG Exerciser speed is set in the Device Structure Dialog (See
Figure 109).