Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 71)

Protocol Analysis
61
Programming the Sequencer
To program the Sequencer, click the Sequencer tab to display the sequencer
programming dialog as shown in Figure 37.
Figure 37 Sequencer Programming Dialog
The sequencer programming dialog opens with default settings and all of the
programmable parameters displayed in blue.
Click the Add State button to add additional states, up to 32.
Program State0
In “State0” you choose, if you want to set a trigger, set an external bit pattern,
start the exerciser, when to start a data capture, what to capture and when to
transition to another state
1. To set the initial sequencer actions, click the ellipses next to “State0”
2. Choose one or all of the available choices one at a time.
Set initial actions: Set trigger, set external bit pattern or start exerciser
Set Start or Stop data capture
Define what to capture
Choose condition for state transition
Choose next state