Teledyne LeCroy PXA125 - Manual (Page 32)

User Manual PXA125
2-18 Installation
CAUTION
The outer shells of the front panel terminals (OUTPUT, SYNC OUT,
TRIG IN, SINEOUT, 10M REF IN) are connected to the instrument’s
chassis and therefore to the safety ground.
CAUTION
Do not attempt to float the OUTPUT from ground as it may damage
the PXA125 and other equipment connected to the PXA125 I/O
connectors.
Calibration The recommended calibration interval is one year. Calibration
should be performed by qualified personnel only.
Operate the PXA125 only as intended by the manufacturer. If you
suspect the PXA125 has been impaired, remove it from the PXI
Chassis and secure against any unintended operation. The
PXA125 protection is likely to be impaired if, for example, the
instrument fails to perform the intended measurements or shows
visible damage. Abnormal
Conditions
WARNING
Any use of the PXA125 in a manner not specified by the
manufacturer may impair the protection provided by the instrument
Long Term
Storage or
Repackaging For
Shipment
If the instrument is to be stored for a long period of time or shipped
immediately, proceed as directed below. If you have any questions,
contact your local LeCroy representative or the LeCroy Customer
Service Department.
1. Repack the instrument using the wrappings, packing material
and accessories originally shipped with the unit. If the original
container is not available, purchase replacement materials.
2. Be sure the carton is well sealed with strong tape or metal
straps.
3. Mark the carton with the model and serial number. If it is to be
shipped, show sending and return address on two sides of the
box.
NOTE
If the instrument is to be shipped to LeCroy for
calibration or repair, attach a tag to the instrument
identifying the owner. Note the problem,
symptoms, and service or repair desired. Record