Teledyne LeCroy PXA125 - Manual (Page 151)

User Manual PXA125
Programming Reference 4-33
:MARKer (?) 64e6,100e-3,100e6
:VOLTage (?) {|MINimum|MAXimum} 5,10e-3,10
:OFFSet (?) 0,-3.6,3.6
:SINusoid
:PHASe (?) 0,0,360
:TRIangle
:PHASe (?) 0,0,360
:SQUare
:DCYCle (?) 50,1,99
:PULSe
:DELay (?) 10,0,99.9
:WIDTh (?) 10,0,99.9
:TRANsition (?) 10,0,99.9
:TRAiling (?) 10,0,99.9
:RAMP
:DELay (?) 0,0,99.9
:TRANsition (?) 60,0,99.9
:TRAiling (?) 30,0,99.9
:SINC
:NCYCle (?) N_cycles> 10,4,100
:GAUSsian
:EXPonent (?) 20,10,200
:EXPonential
:EXPonent (?) -20,-100,+100
:DC (?) <%_amplitude> 100,-100,+100
APPLy:SINusoid{,,,}
Purpose
This command is a high-level command that programs the PXA125 to output sine waveform along with its
associated parameters
•
sets the output frequency in units of hertz
•
sets the output amplitude in units of volts
•
sets the output offset in units of volts
•
sets the output start phase in units of degrees
Parameter type
Numeric
Parameter range
10e3 to 50e6
80e-3 to 8
-3.6 to +3.6
0 to 360
APPLy:SINusoid?
Response
The PXA125 will return , ,,. Default values are
1e6,5,0,0
APPLy:TRIangle{,,,}