Teledyne LeCroy PXA125 - Manual (Page 152)

User Manual PXA125
Programming Reference 4-34
Purpose
This command is a high-level command that programs the PXA125 to output triangular waveform along with
its associated parameters
•
sets the output frequency in units of hertz
•
sets the output amplitude in units of volts
•
sets the output offset in units of volts
•
sets the output start phase in units of degrees
Parameter type
Numeric
Parameter range
10e3 to 50e6
80e-3 to 80
-3.6 to +3.6
0 to 360
APPLy:TRIangle?
Response
The PXA125 will return , ,,. Default values are
1e6,5,0,0
APPLy:SQUare{,,,}
Purpose
This command is a high-level command that programs the PXA125 to output square waveform along with its
associated parameters
•
sets the output frequency in units of hertz
•
sets the output amplitude in units of volts
•
sets the output offset in units of volts
•
sets the squarewave duty cycle in units of %
Parameter type
Numeric
Parameter range
10e3 to 50e6
80e-3 to 8
-3.6 to +3.6
0 to 360
APPLy:SQUare?
Response
The PXA125 will return ,,,. Default values are
1e6,5,0,50
APPLy:PULSe{,,,,,,}
Purpose
This command is a high-level command that programs the PXA125 to output pulse waveform along with its
associated parameters