Motor replacement procedures – IAI America ISPDACR-ESD User Manual
Page 71

63
12. Motor Replacement Procedures
12. Motor Replacement Procedures
(Note) Motors in the ISD, ISDCR and ISPDCR series cannot be replaced by customers. Should you
require motor replacement on any of these actuators, please consult IAI.
12.1 Replacing the Motor of the Standard Type ISDA/ISPDA/ISDACR/ISPDACR Series
* All photographs are those of the ISDACR.
“What you need for replacement”
x New motor (with a coupling on the motor shaft,
as shown in the photograph on the right)
Caution: Never remove this coupling.
x Allen
wrench
set
x Phillips
screwdriver
x Scale
[Steps]
(1) Removing the Motor Cover
Remove the two bolts that secure the motor cover.
Type
Nominal
diameter
Length
(mm)
Quantity
IS(P)DA(CR)-S
M4 12 2
IS(P)DA(CR)-M
M5 20 2
IS(P)DA(CR)-L
M5 25 2
Hold the cover and pull it backward to remove.