IAI America ISPDACR-ESD - Manual (Page 36)

28
4. Installation and Storage/Preservation Environment
4. Installation and Storage/Preservation Environment
4.1 Installation Environment
The actuator should be installed in an environment meeting the following criteria:
x Avoid direct sunlight.
x The machine should not receive radiant heat from strong heat sources such as a furnace.
x The surrounding air temperature should be 0 to 40ºC.
x The relative humidity should be 85% or below and there should be no condensation.
x Avoid exposure to corrosive or combustible gases.
x The cleanroom standards must be satisfied. (Cleanroom types ISDCR/ISPDCR/ISDACR/ISPDACR)
x The area should have very little dust and be suitable for normal assembly operations.
x Avoid exposure to oil mist or fluids using in cutting.
x Avoid exposure to splashed chemical solutions.
x The actuator should not be subject to impact or vibration.
x Avoid extreme electromagnetic waves, ultraviolet rays and radiation.
x Enough work space shall be available to carry out maintenance/inspection.
In general, the environment should be one in which an operator can work without protective gear.
4.2 Storage/Preservation Environment
The storage/preservation environment should be similar to the operating environment. In addition, take
precautions against condensation if the actuator is to be stored/preserved for a long period of time.
Unless otherwise specified, we do not include drying agents when shipping the actuator. If you are storing
the actuator in an environment where condensation might occur, you must treat the entire shipping box, or
treat the actuator itself after unpacking, to prevent condensation. The unit can withstand temperatures up
to 60ºC during a short storage period, but only up to 50ºC if the storage period is longer than one month.
Keep the actuator horizontal during storage/preservation.