IAI America ISPDACR-ESD - Manual (Page 59)

51
10. Maintenance/Inspection
10.3 External Cleaning
x Clean the exterior surfaces from time to time.
x Wipe off dirt with a soft cloth.
x Depending on the situation, base oil of grease may ooze out to the actuator surface. If oil has oozed out,
wipe it off using a soft cloth, etc.
x Do not spray compressed air on the actuator that might force dust into the crevices.
x Do not use petroleum-based solvents as they damage plastic parts and painted surfaces.
x If the unit gets badly soiled, moisten a soft cloth with a neutral detergent or alcohol and wipe the soiled
area gently.
10.4 Adjusting the Stainless Sheet
If the actuator stroke is 400 mm or more, check the stainless sheet as necessary for slack, etc. If the sheet
has slack, adjust the stainless sheet.
[For the procedure to adjust the stainless sheet, refer to 11, “Replacing/Adjusting the Stainless Sheet.”]