2 installing the actuator – IAI America ISPDACR-ESD User Manual
Page 38

30
5. Installation
5.2
Installing the Actuator
Tapped mounting holes are provided on the back of the actuator base. Use these tapped holes to install the
actuator.
How each model should be installed is shown in a section view.
Type
Tap size
Effective tap length
A
S
M6
17 mm
70 mm
M
xMX
M8
20 mm
90 mm
L
xLX
M8
20 mm
120 mm
Tightening torque
Applicable bolt
Bolt seating surface is steel
Bolt seating surface is aluminum
M6
12.3 N-m (1.26 kgf-m)
5.4 N-m (0.55 kgf-m)
M8
30.0 N-m (3.06 kgf-m)
11.5 N-m (1.17 kgf-m)
Tap size
Effective tap length
M8
25 mm
Effective tap
length
Tap size
This manual is related to the following products: