Extron Electronics SMX System User Guide - Manual (Page 82)

SMX System MultiMatrix Switcher • SMX Control Software 76
4. When you are finished assigning icons, click OK to close the device window.
To change an icon in an input or output box, drag the new icon to the box. The previous
icon is replaced.
To remove the icon and leave the box empty, drag an empty square from the Devices
window to the box.
Alternatively, you can display the input and output numbers in the boxes. To do this, select
Numbers in I/O Boxes from the Preferences menu.
Managing Ties
You can create, remove, and view input-to-output ties in the SMX Control program.
To create a tie
• Click and drag an input box outline over to an output box.
• If Hold/Verify Changes has been selected in the Preferences menu, a broken line
connecting the two boxes appears, indicating a pending tie.
NOTE: If you want to undo the pending tie, click Cancel . The broken line
disappears.
Click Take to confirm the tie. The broken line becomes solid.
Figure 38. Completed Ties (Solid) and Pending Ties (Broken Lines)
• If Immediate Changes has been selected from the Preferences menu, the tie is made
immediately, a solid line appears, and the Cancel and Take buttons are not displayed.