Extron Electronics SMX System User Guide - Manual (Page 40)

SMX System MultiMatrix Switcher • SIS Configuration and Control 34
SIS Configuration
and Control
The SMX can be configured and operated using the Extron Simple Instruction Set (SIS) of
commands. SIS commands can be run from a PC connected to either of the SMX serial
ports or the Ethernet port. Use the DataViewer utility or a control system to make serial
control the SMX possible.
This section describes the SIS command method of communication and control. Topics that
are covered, includes:
• RS-232 or RS-422 Link
• Ethernet (LAN) Port
• SIS Programming Guide
• Using the Command and Response Table for SIS Commands
• Using the Command and Response Table for IP SIS Commands
RS-232 or RS-422 Link
The SMX has two ports that can be used for serial control. The default protocols for both
serial ports: 9600 baud, 1 stop bit, no parity, no flow control, 8-bit (see b on page
7 , d on
page 8 , or f on page 16 for connection details).
Ethernet (LAN) Port
The Ethernet connection makes SIS control of the SMX possible using a computer
connected to the same LAN or WAN. The SIS commands and behavior of the unit are
identical whether it is communicating via Ethernet, RS-232 or RS-422 (see page
7 for details
of host device connection through the RS-232 or Ethernet ports).
Ethernet Cable
The Ethernet cable can be terminated as a straight-through cable or a crossover cable and
must be properly terminated for your application (see
Ethernet Control on page 106).
Default IP Addresses
To access the SMX via the Ethernet port, you need the Extron IP address, and may
need the subnet mask and the gateway address. If the IP address has been changed to
an address comprised of words and characters, the actual numeric IP address can be
determined using the ping (CMP) utility (see
Ethernet Control on page 106). The factory-
specified defaults are:
IP address: 192.168.254.254, subnet mask: 255.255.0.0, gateway address: 0.0.0.0