Extron Electronics SMX System User Guide - Manual (Page 32)

SMX System MultiMatrix Switcher • Operation 26
Selecting lock mode 2 or toggling between mode 2 and mode 0
NOTES:
• If the SMX is in lock mode 0, this procedure selects mode 2. The Preset, View, and
Esc buttons flash green twice.
• If the SMX is in lock mode 2, this procedure selects mode 0 (unlocks the switcher).
The View and Esc flash green twice.
Toggle the lock on or off by pressing and holding the Preset, View, and Esc buttons
simultaneously until the buttons flash (approximately 2 seconds).
Press and hold for
2 seconds.
C O N T R O L
ESC VIEW PRESET ENTER
Lock mode 2
Preset, View, and
Esc flash.
C O N T R O L
ESC VIEW PRESET ENTER
Lock mode 0
View and Esc flash.
Press and hold for
2 seconds.
C O N T R O L
ESC VIEW PRESET ENTER
C O N T R O L
ESC VIEW PRESET ENTER
Figure 23. Setting the Executive Lock Mode 2
Selecting lock mode 1 or toggling between mode 2 and mode 1
NOTES:
• If the SMX is in Lock mode 1, this procedure selects mode 2. The Preset, View, and
Esc buttons flash green twice.
• If the SMX is in Lock mode 2, this selects mode 1. The View, and Esc buttons flash
green twice.
Toggle the lock on and off by pressing and holding the View and the Esc button
simultaneously until the buttons flash (approximately 2 seconds).
Press and hold for
2 seconds.
C O N T R O L
ESC VIEW PRESET ENTER
Lock mode 2
Preset, View, and
Esc flash.
C O N T R O L
ESC VIEW PRESET ENTER
Lock mode 1
View and Esc flash.
Press and hold for
2 seconds.
C O N T R O L
ESC VIEW PRESET ENTER
C O N T R O L
ESC VIEW PRESET ENTER
Figure 24. Setting the Executive Lock Mode 1
Setting Background Illuminations
The background illumination can be toggled on or off (default state) as desired from the front
panel. When the background illumination is on, the buttons are lit 25% amber. To toggle
button background illumination off or on, do the following.
• Press and hold inputs 1 and 2 simultaneously, for 3 seconds. All buttons extinguish if lit
amber, or light amber if already off.
NOTE: When in lock mode 1, background illumination cannot be changed.