Extron Electronics SMX System User Guide - Manual (Page 111)

SMX System MultiMatrix Switcher • HTML Configuration and Control 105
Recalling a global preset
To recall a global preset as the current configuration, click the button for the desired preset
in the Global Presets section.
Saving the current configuration as a plane preset
1. In the Plane Preset section, click the plane drop-down list, and select the relevant plane.
2. Click Save Preset . The button changes to Select Preset... , and grays out.
NOTE: All unassigned buttons become active. The global preset field grays out.
3. Select the desired preset by clicking one of the preset buttons.
• To create a new preset, click one of the [unassigned] buttons.
• To overwrite an existing preset, click its button.
4. Enter a name for the preset in the text field.
NOTES:
• Preset names are limited to 12 characters. Valid characters are
0 - 9 , a - z , A - Z , _ : = / and space
• The following characters are invalid or not recommended in the preset names: +
~ , @ = ‘ [ ] { } < > “ ; : | \ ?
5. Click Accept .
If you do not rename an unassigned button, the SMX names the preset as Preset nn
(where nn corresponds to the next plane number).
The SMX retains the same preset name if it is not renamed when it is overwritten.
Recalling a plane preset
To recall a plane preset as the current configuration, on the Plane Presets page, select the
relevant plane, then click the button for the desired preset.