Extron Electronics SMX System User Guide - Manual (Page 29)

SMX System MultiMatrix Switcher • Operation 23
Saving or recalling a global preset
1. Press the Esc button to clear all pending changes. The button flashes green once.
2. Saving a global preset — Press and hold the Preset button until it flashes red.
OR
Recalling a global preset — Press and release the Preset button (lights red). All
previously saved presets also light red. Proceed to step 4.
Step 3.
Press and release the desired (unlit or lit) input or output
button (here output 5, preset 21). The button flashes
red.
Enter button also blinks ( red).
ENTER
Step 4.
Press the Enter button to
save or recall preset.
All buttons extinguish .
C O N T R O L
PRESET ESC VIEW
ENTER
Step 2.
To save a global preset,
press and
hold the Preset
button until it flashes red .
INPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
OUTPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Buttons for any previously saved presets light red
(here preset 8, 18, and 32).
C O N T R O L
PRESET ESC VIEW
INPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
OUTPUTS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
NOTE: To recall a global preset, press and release the Preset button (lights red) .
NOTE: To recall a global preset, press and release a lit Preset button .
Figure 20. Saving or Recalling a Global Preset — An Example
(Steps 2 through 4)
3. Press and release a desired input or output button to select the address to save the
current configuration to. The Address, Preset, and Enter buttons flash red.
NOTE: A preset can be saved to any lit or unlit button. Only presets with lit buttons
can be recalled. When a preset is saved to a lit (previously saved button, the stored
data is overwritten with the new data. Only one preset can be saved to an address
at a time.
4. Press and release the Enter button. The preset is saved or recalled as specified.
Saving or recalling a plane preset
1. Press the Esc button to clear all pending changes. The button flashes green once.
2. Saving a plane preset — Press and hold the Preset button until it flashes red, then
select a plane.
OR
Recalling a plane preset — Press and release the Preset button , which lights red.
All previously saved presets light red, then select a plane.
NOTE: Lit presets are global presets, not plane presets.
3. Press and release a plane button. The button lights.
NOTE: The lit buttons for global presets extinguish, and the buttons for any saved
plane presets light.