Extron Electronics SMX System User Guide - Manual (Page 63)

SMX System MultiMatrix Switcher • SIS Configuration and Control 57
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Set subnet mask EX6) CS } Ips •X6)]
Read subnet mask E CS } X6)]
Set gateway IP address EX5^ CG } Ipg •X5^]
Read gateway IP address E CG } X5^]
Set administrator password EX7$ CA } Ipa •X7$] 12 digits, alphanumeric
Read administrator password E CA } X7$]
Reset (clear) administrator
password E• CA } Ipa •X7$]
Set user password EX7$ CU } Ipu •X7$]
Read user password E CU } X7$]
Reset (clear) user password E• CU } Ipu •X7$]
Set verbose mode EX6# CV } Vrb X6#] Enable or disable verbose
mode and tagged responses,
where additional information
is provided in response to a
query.
NOTE: The SMX can send out unsolicited information (such as a notice of a change in input or some other setting).
This is a verbose (wordy) relationship between the switcher and a connected device. For a direct RS-232 or RS-422
connection, the SMX is set for verbose mode by default. When the SMX is connected via Ethernet, verbose mode is
disabled by default in order to reduce the amount of communication traffic on the network. If you want to use verbose
mode with a switcher connected via Ethernet, you must set this mode to On each time you reconnect to the SMX.
View verbose mode E CV } X6#] Show verbose mode or tagged
response status
X6#
.
Set mail server IP, unit domain
name E
X5^ , X5& , X7$ , X7$ CM }
Ipm •X5^ , X5& , X7$ , X7$ , ] Password (12 digits, user or
admin)
NOTE: Password is option. If no password is being used, type EX5^ , X5& CM ]
Read mail server IP, domain
name E CM } X5^ , X5& , X7$ , X7$ , ]
NOTES:
X5^ = IP/Gateway address ###.###.###.### (server IP address)
X5& = E-mail domain name For example, extron.com
X6) = Subnet mask nnn.nnn.nnn.nnn
255.255.0.0 = default
X6# = Verbose mode 0 = Clear or none (default for Telnet connection)
1 = Verbose mode (default for RS-232 and RS-422 connections)
2 = Tagged responses for queries,
3 = Verbose mode and tagged for queries
X7$ = Password 12 digits and alphanumeric, user or admin