Extron Electronics SMX System User Guide - Manual (Page 60)

SMX System MultiMatrix Switcher • SIS Configuration and Control 54
X6# = Verbose mode 0 = clear/none
(default for Telnet connections)
1 = verbose mode (default for RS-232
and RS-422 connections)
2 = tagged responses for queries
3 = verbose mode and tagged for
queries
X6^ = Baud rate 9600 (default), 9200, 38400, 115200
X6& = Parity O = odd
E = even
N = none
M = mark
S = space
X6* = Data bits 7 , 8
X6( = Stop bits 1 , 2
X7) = Port type 0 = RS-232 (default)
1 = RS-422
2 = RS-485
X7# = Web page priority flag 0 = internal (default factory reset)
1 = user
X7$ = Password 12 digits, alphanumeric
User or admin
NOTES:
• The following characters are invalid or not recommended in the name: ~ , @ = '
[ ] { } < > ` " ; : | \ ? and space
• User password cannot be assigned if no admin password exists (returns error code
E14 ). When admin password is cleared, then user and all security level passwords
are deleted.
X7% = Daylight Saving Time 0 = Daylight Saving Time off or ignore
1 = Daylight Saving Time on
(USA - April to October)
2 = Daylight Saving Time on
(Europe - March to October)
3 = Daylight Saving Time on
(Brazil - October to March)
X7^ = Event number 0 - 99
Event must be running.
X7& = Event data size b = bit
B = byte (8 bits)
S = short (16 bits)
L = long (32 bits)
NOTE: The parameter is case sensitive and may be optionally preceded by A (And) or
O (Or) to logically combine with content instead of replacing it.
X7( = Number of bytes to read 1 - 127
X8) = E-mail event number or mailbox 1 - 64
Response is 3 digits with leading zeros.
X8! = E-mail recipient address