Extron Electronics SMX System User Guide - Manual (Page 43)

SMX System MultiMatrix Switcher • SIS Configuration and Control 37
ppOutnn Volxx ]
The SMX initiates the Vol message when a front panel output audio volume change has
occurred. “ pp ” is the plane address, “ nn ” is the output number, and “ xx ” is the volume level.
ppVmtnn*x ]
The SMX initiates the Vmt message when a video output mute is toggled on or off from the
front panel. “ pp ” is the plane address, “ nn ” is the output number, and “ x ” is the mute status:
1 = on, 0 = off.
ppAmtnn*x ]
The SMX initiates the Amt message when an audio output mute is toggled on or off from the
front panel. “ pp ” is the plane address, “ nn ” is the output number, and “ x ” is the mute status:
1 = on, 0 = off.
Exen ]
The SMX initiates the Exe message when executive mode is toggled on or off from the front
panel. “ n ” is the executive mode status: 1 = on, 0 = off.
Switcher Error Responses
When the SMX receives an SIS command and determines that it is valid, it performs the
command and sends a response to the host device. If the command is invalid or contains
invalid parameters, the SMX returns an error response to the host. The error response
codes are:
E01 — Invalid input channel number (out of range)
E10 — Invalid command
E11 — Invalid preset number
E12 — Invalid output number/port number
E13 — Invalid parameter (out of range)
E14 — Command not available for this configuration
E17 — Timeout (only caused by direct write of global presets)
E22 — Busy
E24 — Privilege violation (Ethernet and Extron software only)
E25 — Device not present
E26 — Maximum number of connections exceeded
E27 — Invalid event number
E28 — Bad filename/File not found
Using the Command and Response Table for SIS Commands
The Command and Response Table begins on page 42. Lowercase letters are
acceptable in the command field except where indicated. Figure 29 shows the hexadecimal
equivalent of ASCII characters used in the command and response tables.
ASCII to Hex Conversion Table
•
Space
Figure 29. ASC II to Hexadecimal Conversion
Symbols are used throughout the table to represent variables in the command and response
fields. Command and response examples are shown throughout the table.