Extron Electronics SMX System User Guide - Manual (Page 73)

SMX System MultiMatrix Switcher • SMX Control Software 67
• EDID settings — Select this option to set the EDID settings for selected inputs, and to
save the output to any of four user defined outputs.
Select Advanced Info to view the EDID data for any selected output (see the above
right side image), and to save a record to a user defined ID (User 1-4).
NOTE: The drop-down list has 41 selections, where: 15 is the default for DVI
(1024x768 @ 60 Hz), 32 is the default for DVI-Pro (720p), 0 = automatic, 1 - 8 is
data stored from connected EDID monitors as reference, 9 - 26 are factory fixed
rates, and 37 - 40 are user assignable ( 37 = User 1, 38 = User 2, 39 = User 3,
40 = User 4). See the EDID table on page 41 for the full list.
• HDCP Status — Select this option to view whether inputs or outputs are connected
with HDCP compliance. This information can also be viewed by selecting
EDID
Settings .
• USB Settings/Status — Select this option to view the connection status and port
emulation settings for USB boards. Select the numbered check boxes in the Port
Emulation section to enable or disable the port emulation feature of SMX USB boards.
• View Input Frequencies — Select this to view the horizontal
and vertical frequencies for any input. Click
Refresh to manually
update the list.
NOTE: If the Frequency-read options setting under
the Preferences menu is set to None , then View Input
Frequencies is not available.