Xylem SDI-12 Data Logger iRIS 220, iRIS 320, iRIS 350, iRIS 150, iRIS 300 - Manual (Page 50)

iRIS Datalogger User Guide V1.50
44 iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 857-0810 Fax: +64 7 857-0811 Email: [email protected]
5.2.7 Totaliser Related Screens
The Totaliser screens show yesterday's total (from 00:00:00 to 23:59:59 yesterday), the daily (since 00:00:00
today) and running (since last totaliser reset) totals for the two pulse input counters.
Total Screen 1/2 (Level 3)
Total 2 Screen 2/2 (Level 3)
Reset Total Screen (Level 4)
The Total Reset screen is used to reset the two daily and the running totals for the selected totaliser.
5.2.8 Comms Related Screens
Comms Status Screen (Level 3)
The Comms Status screen displays the current state of the wireless IP or CSD connection. The RSSI display
shows the Received Signal Strength Indication (RSSI) followed by the Bit Error Rate (BER) for GPRS units
only.
For the GPRS and CDMA models, the RSSI is indicated in relative terms as a value between 0 and 31 with
31 being the theoretical maximum.
For 3G models, the RSSI is displayed in actual dBm.
The iRIS will not attempt to connect if the RSSI value is invalid (0 or 99).
GSM-IP STATUS
Ready
- Off Line -
RSSI: 23,00
TOTAL 1/2
Yesterday 134.6
Today 17.8
Run 5432.4
TOTAL 2/2
Yesterday 76.5
Today 26.4
Run 11276.3
RESET TOTAL
 initiate
+/- Move forwards/backwards through sensor total screens
Enter Drill down to Total Reset screen
Alt Enter Move up to Main Menu screen
+/- Move forwards/backwards through sensor total screens
Enter Drill down to Total Reset screen
Alt Enter Move up to Main Menu screen
Enter Reset total and move up to Sensor Total screen
Alt Enter Move up to Sensor Total screen
Enter Move down to Comms Menu screen
Alt Enter Move up to Main Menu screen