GE Industrial Solutions Entellisys 4.0 System User Manual User Manual
Page 242

Alarms and events
242
A
IP Address for CPUB Set To
[n.n.n.n] From [n.n.n.n]
Logged to record a change in the IP address
for the given CPU
Caution: Firmware Download
Failed for [CPU A/B/Messngr].
Unable to Enable Flash Pgm
Mode. Replace CPU
Contact GE Service for CPU replacement
Contact GE Post Sales Service (see
).
Caution: Firmware Download
Failed for [CPU A/B/Messngr].
Cannot Erase Firmware.Replace
CPU
Contact GE Service for CPU replacement
Contact GE Post Sales Service (see
).
Firmware Downloaded OK To
[CPU A/B/Messngr]
Logged upon successful completion of a CPU
firmware upgrade
Firmware Download Failed for
[CPU A/B/Messngr]
Contact GE Service for CPU replacement
Contact GE Post Sales Service (see
).
Caution: Firmware Download to
[CPU A/B/Messngr] Cannot be
Verified
Contact GE Service for CPU replacement
Contact GE Post Sales Service (see
).
Attention: Flash File Error in
[CPU A/B/Messngr]. Unable to
disable Flash Pgm
Mode.Replace CPU
Contact GE Service for CPU replacement
Contact GE Post Sales Service (see
).
Caution: Firmware Dwnld Failed.
Err Reading Messnger Status for
[Breaker(s)]
An error was detected in confirming the
status of a Messenger prior to upgrading its
firmware.
Contact GE Post Sales Service (see
).
Caution: Firmware Dwnld Failed.
Err Reading Messnger Status
during Switch for [Breaker(s)]
An error was detected in confirming the
status of a Messenger after its firmware has
been updated.
Contact GE Post Sales Service (see
).
Caution: Settings Update
Failed.Retry will Occur in 30
minutes
An attempt to update the local settings file
was unsuccessful and a retry will be
attempted in the specified time period.
If this error is repeated, Contact GE Post Sales
Service (see
Caution: IP Error X For IP
Address [n.n.n.n]
The HMI encountered an error in establishing
a TFTP session with a CPU.
Note: FTP Error X
An error has occurred during FTP protocol
transfer with a CPU. Contact GE Service.
Contact GE Post Sales Service (see
).
Note: TFTP Error X
An error has occurred during TFTP protocol
transfer with a CPU. Contact GE Service.
Contact GE Post Sales Service (see
).
HMI File [Name] Published OK
The HMI successfully updated the specified
file in the CPU
HMI File [Name] Retrieved OK
The HMI successfully retrieved the specified
file from the CPU
Table A-2 Sequence of events description and troubleshooting guide
Event
Description
Notes and Troubleshooting tips