GE Industrial Solutions Entellisys 4.0 System User Manual - Manual (Page 171)

Introduction to FlexLogic 171
11
Table 11-2 describes all available operands available for all entellisys relays and are listed
alphabetically by operand type.
NOTE: While all relay elements and operands are available in FlexLogic, relays that are
optionable will not function unless properly optioned and configured.
Table 11-2 Entellisys FlexLogic operands
OPERAND TYPE OPERAND SYNTAX OPERAND DESCRIPTION
ELEMENT:
Breaker Control BREAKER 1 OPENED
BREAKER 1 CLOSED
BREAKER 1 LOCKED OUT
BREAKER 1 CLOSED SPRING CHRGD
BREAKER 1 PRIMARY CONNECTED
BREAKER 1 PRIMARY DISCONNECTED
BREAKER 1 SECONDARY CONNECTED Breaker 1 open
Breaker 1 closed
Breaker 1 locked out
Breaker 1 closing spring charged
Breaker 1 primary connected
Breaker 1 primary disconnected
Breaker 1 secondary connected
BREAKER 1 AVAILABLE TRUE when both the primary and secondary
disconnects are connected.
BREAKER 1 READY TRUE when the breaker is closed and both
primary and secondary are connected.
BREAKER 1 OPEN FAILED TRUE when open operation failed for the
breaker. The result is set until breaker
opened. Applies to all open and trip
commands: shunt trip open, shunt trip, flux
shifter open, flux shifter trip.
BREAKER 1 CLOSE FAILED TRUE when close operation failed for the
breaker. The result is set until breaker
closed.
BREAKER 1 FAULT TRUE when LT, ST, GF, multipoint relays or
single point relays operated on a fault. The
result is set until the fault is cleared. Breaker
x Fault is returned to false when the breaker
is opened or open time-out (550ms).
BREAKER 2…30 Same set of operands as shown for
BREAKER 1