B&B Electronics ADAM-5000_TCP - Manual - Manual (Page 177)

Planning Your Application Program
$aaSiCjAhs
Name Set Alarm Mode
Chapter 6
Description Sets the High/Low alarm of the specified input chan-
nel in the addressed ADAM-5000/TCP system to
either Latching or Momentary mode.
Syntax $aaSiCjAhs(cr)
$ is a delimiter character.
aa (range 00-FF) represents the 2-character hexadeci-
mal Modbus network address of anADAM-
5000/ TCP system.
SiCj identifies the desired slot i (i : 0 to 7) and the
desired channel j (j : 0 to 7).
Ahs is the Set Alarm Mode command.
h indicates alarm type and can have the value H =
High alarm, L = Low alarm
s indicates alarm mode and can have the value M =
Momentary mode, L = Latching mode
(cr) represents terminating character, carriage return
(0Dh)
Response !aa(cr) if the command was valid There is no
response if the system detects a syntax error or
communication error or if the specified ad- dress
does not exist.
! delimiter character indicating a valid command was
received.
aa represents the 2-character hexadecimal address
of the corresponding ADAM-5000/TCP system.
(cr) represents terminating character, carriage return
(0Dh)
ADAM-5000/TCP User’s Manual 6-109