B&B Electronics ADAM-5000_TCP - Manual - Manual (Page 116)

Planning Your Application Program Chapter 6
Command Syntax Command Name Description
$aaSiER Initialize EEPROM
Data
$aaSi5mm Enable/Disable
Channels for
Multiplexing
Initializes all EEPROM
data in a specified
RTD input module to
their default values
Enables/disables
multiplexing
simultaneously for
separate channels of
the specified input
module
$aaSi6 Read Channels Status Asks a specified input
module to return the
status of all channels
$aaSi0 RTD Span Calibration Calibrates a specified
RTD input module to
correct for gain errors
$aaSi1 RTD Zero Calibration Calibrates a specified
RTD input module to
correct for offset
errors
$aaSi2 RTD Self Calibration Causes a specified
RTD input module of
a specified system to
do a self calibration.
Table 6-4: ADAM-5013 RTD Input command Set Table
ADAM-5000/TCP User’s Manual 6-49