B&B Electronics ADAM-5000_TCP - Manual - Manual (Page 147)

Chapter 6 Planning Your Application Program
Command
Syntax Command
Name Description
Returns the input value of all
channels for a specified
#aaSi All Analog Data In
#aaSiCj
Specified Analog
Data In
$aaSiER
Initialize EEPROM
Data
$aaSi0 Span Calibration
$aaSi1 Zero Calibration
analog input module of a
specified system in currently
configured data format
Returns the input value of a
specified channel of a
specified analog input module
of a specified system in
currently configured data
format
Initializes all EEPROM data in
a specified analog input
module to their default values.
Calibrates a specified analog
input module to correct for
gain errors
Calibrates a specified analog
input module to correct for
offset errors
Table 6-6: ADAM-5017H /5017UH Analog Input command Set
Table
Note: The command sets “ $aasi5mm, $aasi6, $aasi0, $aasi1”
for ADAM-5017H/5017UH are the same with ADAM-5017.
Please refer the preceding pages to learn the detail.
6-80 ADAM-5000/TCP User’s Manual