Rainbow Electronics AT89C5132 User Manual
Page 151
151
AT8xC5132
4173A–8051–08/02
Analog to Digital Converter
Definition of Symbols
Table 141. Analog to Digital Converter Timing Symbol Definitions
Characteristics
Table 142. Analog to Digital Converter AC Characteristics
V
DD
= 2.7 to 3.3V, T
A
= 0 to 70
°
C
Notes:
1. A
V
DD
= AV
REFP
= 3.0V, AV
SS
= AV
REFN
= 0V. ADC is monotonic with no missing code.
2. The differential non-linearity is the difference between the actual step width and the
ideal step width (see Figure 130).
3. The integral non-linearity is the peak difference between the center of the actual step
and the ideal transfer curve after appropriate adjustment of gain and offset errors
(see Figure 130).
4. The offset error is the absolute difference between the straight line which fits the
actual transfer curve (after removing of gain error), and the straight line which fits the
ideal transfer curve (see Figure 130).
5. The gain error is the relative difference in percent between the straight line which fits
the actual transfer curve (after removing of offset error), and the straight line which
fits the ideal transfer curve (see Figure 130).
Waveforms
Figure 129. Analog-to-Digital Converter Internal Waveforms
Signals
Conditions
C
Clock
H
High
E
Enable (ADEN bit)
L
Low
S
Start Conversion
(ADSST bit)
Symbol
Parameter
Min
Max
Unit
T
CLCL
Clock Period
1.43
µ
s
T
EHSH
Start-up Time
4
µ
s
T
SHSL
Conversion Time
11·T
CLCL
µ
s
DLe
Differential non-
linearity error
(1), (2)
TBD
LSB
ILe
Integral non-
linearity error
(1),( 3)
TBD
LSB
OSe
Offset error
(1),(4)
TBD
LSB
Ge
Gain error
(1),( 5)
TBD
%
ADEN Bit
ADSST Bit
T
EHSH
T
SHSL
CLK
T
CLCL