Rainbow Electronics ATmega128L - Manual (Page 212)

212
ATmega128(L)
2467B–09/01
Figure 100. Formats and States in the Slave Receiver Mode
Slave Transmitter Mode In the slave transmitter mode, a number of data bytes are transmitted to a master
receiver (see
Figure 101). All the status codes mentioned in this chapter assume that
the prescaler bits are zero or are masked to zero.
Figure 101. Data Transfer in Slave Transmitter Mode
To initiate the slave transmitter mode, TWAR and TWCR must be initialized as follows:
S SLA W A DATA A
$60 $80
$88
A
$68
Reception of the
own slave address
and one or more
data bytes. All are
acknowledged
Last data byte received
is not acknowledged
Arbitration lost as master
and addressed as slave
Reception of the general call
address and one or more data
bytes
Last data byte received is
not acknowledged
n
From master to slave
From slave to master
Any number of data bytes
and their associated acknowledge bits
This number (contained in TWSR) corresponds
to a defined state of the 2-Wire Serial Bus. The
prescaler bits are zero or masked to zero
P or S DATA A
$80 $A0
P or S A
A DATA A
$70 $90
$98
A
$78
P or S DATA A
$90 $A0
P or S A
General Call
Arbitration lost as master and
addressed as slave by general call
DATA A
Device 3 Device n
SDA
SCL
........ R1 R2
V
CC
Device 2
MASTER
RECEIVER
Device 1
SLAVE
TRANSMITTER