Rainbow Electronics ATmega162V - Manual (Page 253)

253
ATmega162/V
2513E–AVR–09/03
Programming Command
Register The Programming Command Register is a 15-bit register. This register is used to seri-
ally shift in programming commands, and to serially shift out the result of the previous
command, if any. The JTAG Programming Instruction Set is shown in Table 112. The
state sequence when shifting in the programming commands is illustrated in Figure 110.
Figure 109. Programming Command Register
TDI
TDO
S
T
R
O
B
E
S
A
D
D
R
E
S
S
/
D
A
T
A
Flash
EEPROM
Fuses
Lock Bits