Rainbow Electronics DS21458 - Manual (Page 53)

DS21455/DS21458 Quad T1/E1/J1 Transceivers
53 of 270
10. T1 FRAMER/FORMATTER CONTROL REGISTERS
The T1 framer portion of the DS21455/DS21458 is configured via a set of nine control registers.
Typically, the control registers are only accessed when the system is first powered up. Once the device
has been initialized, the control registers will only need to be accessed when there is a change in the
system configuration. There are two receive-control registers (T1RCR1 and T1RCR2), two transmit
control registers (T1TCR1 and T1TCR2), and a common control register (T1CCR1). Each of these
registers is described in this section.
10.1 T1 Control Registers
Register Name:
T1RCR1
Register Description: T1 Receive Control Register 1
Register Address: 03h
Bit
# 7 6 5 4 3 2 1 0
Name — ARC OOF1 OOF2 SYNCC SYNCT SYNCE RESYNC
Default 0 0 0 0 0 0 0 0
Bit 0/Resynchronize (RESYNC). When toggled from low to high, a resynchronization of the receive side framer is initiated.
Must be cleared and set again for a subsequent resync.
Bit 1/Sync Enable (SYNCE).
0 = auto resync enabled
1 = auto resync disabled
Bit 2/Sync Time (SYNCT).
0 = qualify 10 bits
1 = qualify 24 bits
Bit 3/Sync Criteria (SYNCC).
In D4 Framing Mode:
0 = search for Ft pattern, then search for Fs pattern
1 = cross couple Ft and Fs pattern
In ESF Framing Mode:
0 = search for FPS pattern only
1 = search for FPS and verify with CRC6
Bits 4 to 5/Out-of-Frame Select Bits (OOF2, OOF1).
OOF2 OOF1 OUT-OF-FRAME CRITERIA
0 0 2/4 frame bits in error
0 1 2/5 frame bits in error
1 0 2/6 frame bits in error
1 1 2/6 frame bits in error
Bit 6/Auto Resync Criteria (ARC).
0 = resync on OOF or RCL event
1 = resync on OOF only
Bit 7/Unused, must be set to zero for proper operation.