5 how to change the graphic volume range, Loading the track in the volume automation panel, Adapting the graphic volume range – EVS IPDirector Version 5.8 - July 2010 Part 7 User's Manual User Manual
Page 195: How to change the graphic volume range
Issue 5.8.B
IPDirector V.5.8 – User Manual – Part 7: Editing - IPEdit
EVS Broadcast Equipment - July 2010
182
4.14.5 H
OW TO
C
HANGE THE
G
RAPHIC
V
OLUME
R
ANGE
In order to …
Click one or more times …
increase the graphic
volume range above
the 0 db line,
the upper arrow in the Maximum Graphic Volume Range
spin box
until the requested value for the range is displayed
decrease the graphic
volume range above
the 0 db line,
the lower arrow in the Maximum Graphic Volume Range
spin box until the requested value for the range is
displayed.
increase the graphic
volume range below
the 0 db line,
the upper arrow in the Minimum Graphic Volume Range
spin box
until the requested value for the range is displayed.
decrease the graphic
volume range below
the 0 db line,
the lower arrow in the Minimum Graphic Volume Range
spin box until the requested value for the range is
displayed.
4.14.6 P
RELIMINARY
A
CTIONS
B
EFORE
A
NY
I
NCREASE OR
D
ECREASE ON THE
V
OLUME
A
UTOMATION
C
URVE
Before you increase or decrease the volume automation curve, go through the
following steps:
L
OADING THE
T
RACK IN THE
V
OLUME
A
UTOMATION
P
ANEL
To enter the volume automation mode and load the track in the Volume Automation
panel, click the Volume Automation Mode icon
next to the track where you
want to increase or decrease the volume.
A
DAPTING THE
G
RAPHIC
V
OLUME
R
ANGE
You need to ensure that the graphic volume range displayed allows you to perform
the increase or decrease action you want to.
If this is not the case, change the graphic volume range. For more information,
refer to section 4.14.5 ‘How to Change the Graphic Volume Range’, on page 182.