Garmin G1000 Mooney M20TN - Manual (Page 75)

190-00647-00 Rev. A Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN 3-5
EIS
Accessing the EIS Lean Display:
1) Press the ENGINE Softkey.
2) Press the LEAN Softkey.
3) To return to the default Engine Display, press the ENGINE or BACK Softkey.
1 Engine Manifold Pressure
Gauge (MAN IN)
Displays engine power in inches of Mercury (in Hg)
Turbocharged Aircraft – Maximum manifold pressure range shown in red
2 Tachometer
(RPM)
Shows propeller speed in revolutions per minute (rpm); the red area
indicates propeller overspeed
3 Fuel Quantity Indicator
(FUEL QTY GAL)
Displays the amount of fuel in gallons (gal) for each tank (L and R)
Standard Tanks – Indicator displays up to 44.5 gal when full (F)
Long Range Tank Option – Allows 55 gal per side (110 gal total), although
the indicator range is the same as for standard tanks. The pointers
show tanks as full until the fuel quantity decreases below 44.5 gal.
4 Fuel Flow Indicator
(FFLOW GPH)
Displays fuel flow in gallons per hour (gph)
5 Turbine Inlet Temperature
Indicator (TIT °F)
Turbocharged Aircraft
Displays the temperature at the turbine inlet in degrees Fahrenheit (°F)
6 Exhaust Gas Temperature Bar
Graph (EGT °F)
The bar of the cylinder with the highest Exhaust Gas Temperature
(EGT) is highlighted in light blue and its readout given below the bar
graph in degrees Fahrenheit (°F).
7 Trim Group
(FLAPS, ELEV TRIM)
Flap position (UP, T/O, DN) is denoted; when the flaps are in transit
between positions, /// is displayed (see Figure 3-5)
Elevator trim is displayed on a slide bar; the white portion of the bar
represents the correct takeoff trim range
8 Cylinder Head Temperature
Bar Graph (CHT °F)
The bar of the cylinder with the highest head temperature is highlighted
in light blue and its readout given below the bar graph in degrees
Fahrenheit (°F).
Caution and warning conditions for each cylinder are denoted by color
change of the cylinder’s bar to yellow or red, respectively.