Flight instruments, Dme information window – Garmin G1000 Piper PA-46 Matrix User Manual
Page 80
Garmin G1000 Pilot’s Guide for the Piper PA-46 Mirage/Matrix
190-01108-00 Rev. B
66
FLIGHT INSTRUMENTS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
If the NAV radio is the bearing source and is tuned to an ILS frequency (refer to the Audio Panel and CNS
Section for information on tuning the radios), the bearing pointer is removed from the HSI and the frequency
is replaced with “ILS”. When NAV1 or NAV2 is the selected bearing source, the frequency is replaced by the
station identifier when the station is within range. If GPS is the bearing source, the active waypoint identifier
is displayed in lieu of a frequency.
The bearing pointer is removed from the HSI and “NO DATA” is displayed in the information window if:
• The NAV radio is not receiving the tuned VOR station
• GPS is the bearing source and an active waypoint is not selected
Selecting bearing display and changing sources:
1)
Select the PFD Softkey.
2)
Select a BRG Softkey to display the desired bearing pointer and information window with a NAV source.
3)
Select the BRG Softkey again to change the bearing source to GPS.
4)
Select the BRG Softkey a third time to change the bearing source to ADF (note: ADF radio installation is
optional).
5)
To remove the bearing pointer and information window, select the BRG Softkey again.
DME INFORMATION WINDOW
NOTE:
DME radio installation is optional.
The DME Information Window (Figure 2-21) is displayed above the BRG1 Information Window and shows
the DME label, tuning mode (NAV1, NAV2, or HOLD), frequency, and distance. When a signal is invalid,
the distance is replaced by “–.– – NM”. Refer to the Audio Panel and CNS Section for information on tuning
the radios.
Displaying the DME Information Window:
1)
Select the PFD Softkey.
2)
Select the DME Softkey to display the DME Information Window above the BRG1 Information Window.
3)
To remove the DME Information Window, select the DME Softkey again.