Garmin G1000 Piper PA-46 Matrix - Manual (Page 559)

190-01108-00 Rev. B Garmin G1000 Pilot’s Guide for the Piper PA-46 Mirage/Matrix
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
545
APPENDIX A
Message Comments
GWX SERVICE – GWX needs service.
Return unit for repair.
A failure has been detected in the GWX 68. The GWX 68 may still be usable.
MANIFEST – GWX software
mismatch, communication halted.
The GWX 68 has incorrect software installed. The G1000 system should be serviced.
WX ALERT – Possible severe weather
ahead. The GWX 68 indicates severe weather within ±10 degrees of the aircraft heading at a
range of 80 to 320 nm.
GDC 74A MESSAGE ADVISORIES
Message Comments
ADC1 ALT EC – ADC1 altitude error
correction is unavailable.
GDC1 or GDC2 is reporting that the altitude error correction is unavailable.
ADC2 ALT EC – ADC2 altitude error
correction is unavailable.
ADC1 AS EC – ADC1 airspeed error
correction is unavailable.
GDC1 or GDC2 is reporting that the airspeed error correction is unavailable.
ADC2 AS EC – ADC2 airspeed error
correction is unavailable.
MANIFEST – GDC1 software
mismatch, communication halted.
The GDC 74B has incorrect software installed. The G1000 system should be serviced.
MANIFEST – GDC2 software
mismatch, communication halted.
GCU 476 MESSAGE ADVISORIES
Message Comments
GCU CNFG – GCU Config error.
Config service req’d. GCU 475 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
GCU FAIL – GCU is inoperative. A failure has been detected in the GCU 475. The GCU 475 is unavailable.
MANIFEST – GCU software mismatch,
communication halted.
The GCU 475 has incorrect software installed. The G1000 system should be serviced.
GCU KEYSTK – GCU [key name] Key
is stuck. A key is stuck on the GCU 475 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.
GMC 710 MESSAGE ADVISORIES
Message Comments
GMC CONFIG – GMC Config error.
Config service req’d.
Error in the configuration of the GMC 710.
GMC FAIL – GMC is inoperative. A failure has been detected in the GMC 710. The GMC 710 is unavailable.
MANIFEST – GMC software
mismatch. Communication halted.
The GMC 710 has incorrect software installed. The G1000 system should be serviced.
GMC KEYSTK – GMC [key name] Key
is stuck. A key is stuck on the GMC 710 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.