Garmin G1000 Piper PA-46 Matrix - Manual (Page 263)

190-01108-00 Rev. B Garmin G1000 Pilot’s Guide for the Piper PA-46 Mirage/Matrix 249
FLIGHT MANAGEMENT
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
The G1000 WAAS GPS allows for flying LNAV, LNAV/VNAV, and LPV approaches according to the published
chart. LNAV+V is a standard LNAV approach with advisory vertical guidance provided for assistance in
maintaining a constant vertical glidepath similar to an ILS glideslope on approach. This guidance is displayed
on the G1000 PFD in the same location as the ILS glideslope using a magenta diamond. In all cases where
LNAV+V is indicated by the system during an approach, LNAV minima are used. The active approach type
is annunciated on the HSI as shown in the following table:
HSI Annunciation Description Example on HSI
LNAV GPS approach using published LNAV minima
Approach Type
- LNAV
- LNAV+V
- L/VNAV
- LPV
LNAV+V GPS approach using published LNAV minima.
Advisory vertical guidance is provided
L/VNAV GPS approach using published LNAV/VNAV
minima
LPV GPS approach using published LPV minima
Table 5-9 Approach Types
LOADING AN APPROACH INTO THE ACTIVE FLIGHT PLAN
Loading an approach into the active flight plan using the PROC Key:
1) Press the PROC Key. The Procedures Window is displayed.
2) Highlight ‘SELECT APPROACH’, and press the ENT Key. The Approach Loading Page is displayed..
3) Use the FMS Knob to select an airport and press the ENT Key.
4) Select an approach from the list and press the ENT Key.
5) Select a transition (if required) and press the ENT Key.
6) Minimums
a) To set ‘MINIMUMS’, turn the small FMS Knob to select ‘BARO’, and press the ENT Key. Turn the small FMS
Knob to select the altitude, and press the ENT Key.
Or :
b) To skip setting minimums, press the ENT Key.
7) Press the ENT Key with ‘LOAD?’ highlighted to load the arrival procedure; or turn the large FMS Knob to
highlight ‘ACTIVATE’ and press the ENT Key to load and activate the approach procedure.
NOTE: When GPS is not approved for the selected final approach course, the message ‘NOT APPROVED
FOR GPS’ is displayed. GPS provides guidance to the approach, but the HSI must to be switched to a NAV
receiver to fly the final course of the approach.