Xerox 480 ST - Manual (Page 69)

Xerox Document Centre System Administration Guide Page 9 - 1
9.
Mi
cr
os
oft
(T
CP
/I
P
)
Net
w
or
ks
9.
M
ic
rosoft
(T
CP
/I
P
)
N
e
tw
orks
9. Microsoft (TCP/IP) Networks
Before You Start
NOTE Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If you have a DHCP server and
it is set to provide host name, IP address, Gateway address, and
Subnet Mask, the Document Centre TCP/IP information will be
configured on initial boot.
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
For information on how your printer can connect to a BOOTP
server, or a RARP server to be assigned an IP address dynamically,
refer to the chapter in this document entitled Dynamic/Static IP
Addresses & WINS Information in regards to static IP address
configuration may be found within that section as well.