Xerox 480 ST - Manual (Page 307)

Xerox Document Centre System Administration Guide Page 22 - 1
2
2
. P
o
rt
9100
P
ri
n
ti
ng
22. Port 9100 Printing
Introduction
Your Document Centre supports printing from a variety of operating
systems that support TCP/IP and now supports Port 9100 (RAW)
printing, including Linux and Windows 2000.
NOTE Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot.
Your Document Centre has DHCP enabled by default. If your
DHCP server is configured with the TCP/IP information for the
Document Centre, you should Skip Steps 5 and 6 in this procedure
and go to Step 7 to enable Port 9100 printing. If you wish to
configure your TCP/IP information statically, complete ALL Steps
on the following pages.