Xerox 480 ST - Manual (Page 34)

Page 3 - 6 Xerox Document Centre System Administration Guide
Static Addressing
NOTE Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If you have a DHCP server and
it is set to provide host name, IP address, Gateway address, and
Subnet Mask, the Document Centre TCP/IP information will be
configured on initial boot. This procedure assumes you will set the
IP information manually.
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
For information on how your printer can connect to a DHCP,
BOOTP, or a RARP server to be assigned an IP address
dynamically, refer to the section in this chapter entitled Dynamic
Addressing (DHCP, BOOTP, or RARP).