Xerox 480 ST - Manual (Page 311)

Xerox Document Centre System Administration Guide Page 22 - 5
22. P
o
rt
91
00
Pr
in
ti
n
g
22
. Po
rt
91
0
0
Pr
in
ti
n
g
6. Set the Subnet Mask and Gateway.
a) Press the Subnet and Gateway button.
b) Press the soft buttons on the Touch Screen one at a time
for each octet of the Subnet Mask and enter the numbers
using the keypad.
c) Repeat this process for the IP Gateway address. When
finished press Save to record the changes and exit to the
TCP/IP Settings screen.
d) Press Close.
e) If you need to lp or lpr print press the TCP/IP - Line
Printer button, press Enable then press Save.
NOTE The Broadcast Address will be calculated automatically.
7. Enable Port 9100 printing .
a) Press the RAW TCP/IP Printing button.
b) Press Enable.
c) Press Save.
8. Enable HTTP/IPP protocol.
a) Press the HTTP/IPP button.
b) Press Enable.
c) Press Save.
9. Exit the Tools Menu
a) Press the Exit Tools button.