Xerox 480 ST - Manual (Page 308)

Page 22 - 2 Xerox Document Centre System Administration Guide
Before You Start
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment. Then return here and perform this prodecure.
For Dynamic TCP/IP Addressing, use the DHCP, BOOTP, or
RARP Instructions found in this document in the section entitled
Dynamic/Static TCP/IP Addresses and WINS to connect it to the
appropriate server then return here to complete the setup.
Record the following information assigned to your Document
Centre:
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________