Xerox 480 ST User Manual
Page 32
Page 3 - 4
Xerox Document Centre System Administration Guide
6.
Select either DHCP, BOOTP, or RARP as the dynamic
address source.
a) Press
the
Dynamic Addressing button. By default,
DHCP will be selected. To disable DHCP, choose
another dynamic addressing method (BOOTP, DHCP,
DHCP/AutoNet, RARP) or Disabled, and press Save.
b) Press
the
Exit Tools button. Wait approximately 2 min-
utes before you continue to Step 7.
7.
Print a Configuration Report page to verify the DocuCentre
TCP/IP information was assigned correctly by the dynamic
server.
a) Repeat Steps 3a and 3c.
b) Select
System Setting.
c) Select
Configuration Report.
d) Select
Print Configuration Report Now.
e) Press
the
Cancel button.
f) Press
the
Exit Tools button.
8.
Set the Host Name
a) Repeat Steps 3a - 5a.
b) Press
the
Name/Address button.
c) Press
the
Host Name button.
d) By default, the Document Centre assigns a default host
name. To change the host name, type the host name
EXACTLY as you want it to appear with correct case.
When finished press the Save button to record the
changes and exit to the TCP/IP Settings screen.
NOTE
The Document Centre will only accept one Gateway address from a
DHCP server.
9.
Set Subnet Mask and Gateway Address.
a) Press
the
Subnet and Gateway button.
b) Press the soft buttons on the Touch Screen one at a time
for each octet of the Subnet Mask and enter the numbers
from the keypad.