Xerox 480 ST - Manual (Page 35)

Xerox Document Centre System Administration Guide Page 3 - 7
3.
Dy
nami
c/
St
at
ic
IP
Addr
es
se
s and
WI
NS
3
. Dyn
a
mic
/S
ta
ti
c
IP
Ad
dre
ss
e
s and WIN
S
Go to the Document Centre and...
1. Connect your Document Centre to the network with the
appropriate cabling.
2. Enter the Tools pathway.
a) Press the Access ( or ) button.
b) On the keypad enter 1111 or the current password. Press
the Enter button when finished. The Touch Screen will
be used for the remainder of the data entry, unless
instructed otherwise.
c) Press the Go to Tools button.
3. Enter the Network Setup menus.
a) Wait for the screen to refresh and press the Connectivity
and Network Setup button.
b) Wait for the screen to refresh and press the Network
Setup button.
4. Enable TCP/IP protocol.
a) Press the TCP/IP Options button.
b) Press the TCP/IP Settings button.
c) Press the Protocol and Media button.
d) Press the Enable button. If Physical Media buttons
appear, select either Ethernet or Token Ring. Press
Save.
5. Select either DHCP, BOOTP, or RARP as the dynamic
address source.
a) Press the Dynamic Addressing button. By default,
DHCP will be selected. To disable DHCP, choose
another dynamic addressing method or Disabled. Press
Save.
6. To enter the IP address and Host Name.
a) Press the Name/Address button.
b) Press the soft buttons one at a time on the touch screen
for each Octet of the IP address and enter the numbers
from the keypad.