ZyXEL Communications Internet Security Gateway ZyWALL 100 - Manual (Page 86)

ZyWALL 100 Internet Security Gateway
Remote Node Setup 9-3
Table 9-1 Fields in Menu 11.1
FIELD DESCRIPTION EXAMPLE
Rem Node
Name Enter a descriptive name for the remote node. This field can be up
to eight characters. LAoffice
Active Press [SPACE BAR] and then [ENTER] to select Yes (activate
remote node) or No (deactivate remote node). Yes
Encapsulation Ethernet is the default encapsulation. Press [SPACE BAR] and then
[ENTER] to change to PPPoE or PPTP encapsulation. Ethernet
Service Type Press [SPACE BAR] and then [ENTER] to select from Standard,
RR-Toshiba (RoadRunner Toshiba authentication method) or RR-
Manager (RoadRunner Manager authentication method). Choose
one of the RoadRunner methods if your ISP is Time Warner's
RoadRunner; otherwise choose Standard. Standard
Service Name If you are using PPPoE encapsulation, then type the name of your
PPPoE service here. Only valid with PPPoE encapsulation. poellc
Outgoing
My Login This field is applicable for PPPoE encapsulation only. Enter the
login name assigned by your ISP when the ZyWALL calls this
remote node. Some ISPs append this field to the Service Name
field above (e.g., jim@poellc) to access the PPPoE server.
jim
My Password Enter the password assigned by your ISP when the ZyWALL calls
this remote node. Valid for PPPoE encapsulation only.
*****
Server IP This field is valid only when RoadRunner is selected in the Service
Type field. The ZyWALL will find the RoadRunner Server IP
automatically if this field is left blank. If it does not, then you must
enter the authentication server IP address here.
Route This field refers to the protocol that will be routed by your ZyWALL –
IP is the only option for the ZyWALL 100. IP
Edit IP This field leads to a “hidden” menu. Press [SPACE BAR] to select
Yes and press [ENTER] to go to Menu 11.3 - Remote Node
Network Layer Options. No
(default)
Session Options
Edit Filter sets
This field leads to another “hidden” menu. Use [SPACE BAR] to
select Yes and press [ENTER] to open menu 11.5 to edit the filter
sets. See the Remote Node Filter section for more details. No
(default)
Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to
save your configuration, or press [ESC] at any time to cancel.