ZyXEL Communications Internet Security Gateway ZyWALL 100 - Manual (Page 104)

ZyWALL 100 Internet Security Gateway
Backup Remote Node Setup 10-5
10.3 Editing TCP/IP Options
Move the cursor to the Edit IP field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER]
to open Menu 11.3 - Network Layer Options.
Figure 10-4 Menu 11.3 — Remote Node Network Layer Options
The next table gives you instructions about configuring remote node network layer options.
Table 10-2 Remote Node Network Layer Options Menu Fields
FIELD DESCRIPTION EXAMPLE
Rem IP
Address Leave this field set to 0.0.0.0 to have the ISP or other remote router
dynamically (automatically) send its IP address if you do not know it.
Enter the remote gateway’s IP address here if you know it (static). 0.0.0.0
(default)
Rem IP
Subnet
Mask Leave this field set to 0.0.0.0 to have the ISP or other remote router
dynamically send its subnet mask if you do not know it. Enter the remote
gateway’s subnet mask here if you know it (static). 0.0.0.0
(default)
My WAN
Addr Leave the field set to 0.0.0.0 to have the ISP or other remote router
dynamically (automatically) assign your WAN IP address if you do not
know it. Enter your WAN IP address here if you know it (static).
This is the address assigned to your local ZyWALL, not the remote
router.
0.0.0.0
(default)
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Network Address Translation= None
Metric= 15
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
Enter here to CONFIRM or ESC to CANCEL: